This never showed up on the list, so here it is again.
Hal
Oh yes,
"drill size 21/64".
Pipe threads are bizzare.
Hal
-----Original Message-----
From: spridgets-bounces+hal=katemuir.com@autox.team.net
[mailto:spridgets-bounces+hal=katemuir.com@autox.team.net]On Behalf Of
Hal Faulkner
Sent: Saturday, August 25, 2007 11:08 AM
To: WJHS1960; Spridgets
Subject: Re: [Spridgets] valve guides
Missed the post that this is a response to, but....
The tap that I used to chase the threads on the air holes on my 12G1316 head
is clearly marked 1/8-27 NPT. Much bigger in diameter than 1/8".
Hal
-----Original Message-----
From: spridgets-bounces+hal=katemuir.com@autox.team.net
[mailto:spridgets-bounces+hal=katemuir.com@autox.team.net]On Behalf Of
WJHS1960
Sent: Friday, August 24, 2007 3:04 PM
To: Spridgets
Subject: Re: [Spridgets] valve guides
<<not 1/8-27 pipe thread...>>
Yep. 1/8 would just fall inside<G>!!
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|