I was considering welding some tabs or another piece of angle on the
other side to make it work...
Marc
Brad Fornal wrote:
> That is just like the seat rails in the 68 Sprite. I also was needing
> one. I had some out of the early 70's cars, so I did the only thing I
> could think of. I took one of each to a welding shop. I had them cut
> the base off the 70 rail, and flip it over, and reweld it so that I
> had the "C" style, rather than the "Z" style. It doesn't look too bad,
> and only cost me $10 labor.
> Best part is, it works, without redrilling the car.
>
> Brad
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|