Re[4]: timing question

To:	"David Ramsey" <dwramsey@worldnet.att.net>
Subject:	Re[4]: timing question
Date:	Sun, 4 Dec 2005 09:17:12 -0800
Cc:	spridgets <spridgets@autox.team.net>
References:	<1347197010.20051203194014@pacifier.com> <20051204153035.0D0BF79BE@mx9.pacifier.net>

Hello David,

       i understand marking at 30 degrees... but at what rpm should
       this be taking place? .. right now i'm at about 10 degrees at
       about 1000 -> 1200 rpms.... .....

       is 30 degrees where it would be if i static timed then started
       it?... ... that is, static time at the "book" 8 degrees? .. and


       DR> So mark your crank pulley at 30deg advanced.
DR>                 Crash

DR> i also have a good bright timing light so i can do that
DR>        way too.... (unfortunately it is NOT the adjustable kind.)





        

-- 
Best regards,
 Bill                            mailto:pythias@pacifier.com

<Prev in Thread]	Current Thread	[Next in Thread>
timing question, owner-spridgets timing question, Unknown Re: timing question, owner-spridgets Re: timing question, Unknown Re: timing question, owner-spridgets Re: timing question, Unknown Re[2]: timing question, owner-spridgets Re[2]: timing question, Unknown Re[4]: timing question, owner-spridgets Re[4]: timing question, Unknown <=

Previous by Date:	Re[4]: timing question, owner-spridgets
Next by Date:	Re: my next car..., owner-spridgets
Previous by Thread:	Re[4]: timing question, owner-spridgets
Next by Thread:	!500 engine specs, owner-spridgets
Indexes:	[Date] [Thread] [Top] [All Lists]