I've used one. About all I can say is that it does work as long as there is
no air gap between the two pieces and you hold the contact the correct
amount of time. It takes some practice to hit that time just right. If the
contact is too short the weld will not hold, if it's too long you will just
burn a hole.
----- Original Message -----
From "Charlie Shelden" <shelden3 at pldi.net>
To: <spridgets@autox.team.net>
Sent: Sunday, March 14, 2004 9:04 PM
Subject: spot welder
> I'm itching to buy something and have been looking at the eastwood
cataloge.
> They offer a spot weld gun that attaches to your stick welder leads, this
> one has small weld sticks for making the arc. Has anyone used one of
these?
> Did it work ok? I have a 90amp GMAW rig, I'd planned to use and will use.
> But this may be a handy tool as well, I'd use it with my lincoln arc
setup.
|