So.... If a DFPO had stripped all 3 front shock mounting holes, drilled and
tapped them to 1/2", and drilled out the shock holes to match, (and you
need to replace the shocks otherwise) would you....
a) Replace the shocks and drill the replacements? (there are good reasons
to NOT do this, shock-wise)
b) Heli-coil (or whatever brand) the holes in the frame back to 3/8"? Is
that safe?
c) Do it right by welding in new plates? (we'd rather not go that far into
the project at this time)
Suggestions welcome. Thanks Peter C.
|