Let me know what needle you use - it'll be a good starting point for me (if you
get to that point before I do).
I used a program called WinSu that I found online. It calculated BDK as a
first recommendation, with BDD and BDR as additional options.
Phil
|-----Original Message-----
|From: Mike MacLean [mailto:macleans@earthlink.net]
|Sent: Friday, April 18, 2003 2:17 PM
|To: Phil Profili
|Cc: Spridget List
|Subject: Re: Valves - are the expensive ones worth it?
|
|
|Phil,
| Yes, that would be the 1.4" intakes. Of course you will
|need the larger seat machined in also. If you only do the
|intake valve, there should be room. I am getting a HIF 1 3/4
|inch carb from someone on the list that already had a similar
|setup to this. I'll start with his needle, but I will have to
|change it probably as soon as the motor is broken in and I can
|get it dyno'ed. You may expect a real "kick
|in the pants" with the setup you are building!
|Mike
|
|
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|