I have an angle brace for it but it still needs to be cleaned (rust),
drilled and painted first. I needed to know the spacing before I do that
though. Going to work on that this week. I don't plan on rolling it
around until I get that completed.
Herby
64 MKII Sprite (Herbytoy - patiently waiting)
62 MKII Sprite (the "resto-mod" driver)
billh@aaai.com
www.herbytoys.com
Hi Bill,
Sure puts new meaning to the the phrase, "Think I'll take my car for a
spin!"
Nice looking set up. I didn't see that they were connected together,
though. No
chance of one upending easily?
Regards, Paul A
Bill Hunt wrote:
> I finally finished my rotisserie (no, not barbecue!!!) and got
Herbytoy
> mounted up on it. See the pictures at
> http://www.herbytoys.com/trick_ideas.htm . I don't have the dimensions
> written down but can get them. It's pretty simple to make with very
> minimal welding. I haven't "tilt" tested yet but it appears to be
sturdy
> so far and rolls fairly easy. Next step is to remove all the
suspension
> pieces. Yes, I know it would have been easier to do it on the ground
and
> I may still do that.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|