In a message dated 1/11/03 4:13:21 AM, DLancer7676@cs.com writes:
<<
And use a long sanding block that spans the width of the header so you can be
sure to sand it all evenly. Less likely to develop a leak if the whole
affair is true. Another way would be to rubber cement the emory paper to
your flat workbench top or tack it over a board and rub the header over that
to keep it true. >>
I should have said that. Thanks David.
Annice & Bob
1960 Bugeye (Mk. IV in disguise) "The Sprite"
1966 Sprite Mk. III (Still in Boxes) "Trevor"
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|