In a message dated 1/10/03 10:51:56 AM, denadave@attbi.com writes:
<< Will I get a
good seal at the manifold with powder coating on the port area or do I need
to get it milled off to have a metal surface for the exhaust gasket to rest?
>>
If it went on at high temperature, it won't matter; but if it makes you feel
better, you can get a sanding block and sand it off. Use a good emery paper
rather than regular "sandpaper."
Annice & Bob
1960 Bugeye (Mk. IV in disguise) "The Sprite"
1966 Sprite Mk. III (Still in Boxes) "Trevor"
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|