Hi All,
It's been a busy Summer. Wish I had more time to spend on the list, but
with all that has happened, I just haven't had the time.
I was asked about separating the kingpins from the aframes. I have
never performed this op. But I have resourses that have. So How do you
get the Aframe apart from the Kingpins? It looks like there is a small
tapered pin that needs to be driven out. Then the stud that holds it
onto the A-frame will unscrew. How do you drive the pin out, and with
what can you grasp the stud? It looks like I can't get two nuts on it
to remove it like a head bolt. Is it a throw away after you remove the
stud because you tear up the threads with vice grips?
Wrong way Rickie
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|