Sent this earlier, but it didn't appear, so I'm sending again.
Greg,
Get a hold of John Carey. There was a place in San Jose but heard the guy
who was familiar with this setup recently retired. I think he told me there
is someone in Sacramento. I know there was aldo a place in the midwest
somewhere, but can't remember the name of the place anymore.
Jay F., if you can reach Randy, he's the one who told me about it.
Glad you're enjoying the book... wish my copy would show up!...'-)
Gerard
At 6:02 PM -0800 2/11/02, Greg Gowins wrote:
>Hello fellow listers,
>
>Daniel's book arrived in the mail today! The envelope looks like it got
>the once over going through customs, but the book emerged unscathed.
>
>Very good content all through the book. He doesn't stick to the
>"factory" methods of tuning, and covers all sorts of aftermarket
>enhancements, most of which are readily available. This book definitely
>fills a void in my Spridget book collection.
>
>Now for a question to pose to the group. Has anyone else here had the
>1st gen RX-7 rear end cut down to fit a Spridget? I've got one sitting
>in my garage, but am having a hard time finding a driveline shop to do
>the work. If anyone here has tips and/or measurements on getting this
>done, I'd much appreciate it.
>
>Greg Gowins
>'69 Sprite
>Dublin, CA
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|