Chuck,
Try using "Kopr-Shield" it's a small 11/2 oz. container with a brush applicator.
It's made by Thomas & Betts Corp. of Bridgewater, New Joisey. I think I found
it
at my local hardware store. Anyone else use this and where can Chuck find it?
I use it on the connectors, battery terminals, etc. I used to have trouble w/
the bugeye horn and its connectors; no problem for over a year.
I just dipped the connector in the grease and slid them together.
I have also used Dielectric Silicone in a tube. It was originally for "modern"
distributors among other things.
Hope this helps,
Dave
59 :{)
59 MGA 1500
chuck wrote:
> OK, I've got that out of my system....
>
> After spending quite a while tracing, fixing, refixing, and
> re-refixing a problem with my right-side high beam, I
> conclude that there must be a preferable alternative to the
> Lucas bullet-connector system. The bullets themselves
> are not so bad. You just gotta clean 'em sometimes.
> But the hollow, pre-rusted, tubular (that's the punch
> line in an old Spike Jones number -- TUBULAR!)
> connectors seem to rust, corrode, and otherwise fall apart
> no longer maintaining good contact with dem bullets.
>
> Is there a better way? Or do I just order another gross
> of single- and double connectors from the usual suspicious
> sources?
>
> chuckC
|