Bob,
On the seats, I use them as is but do flatten the rear legs a bit. I leave
the angled front legs because I like the extra thigh support provided by
the extra lift. I also make a couple mounting bars that are attached though
the stock front bolt holes. I then drill and tap bolt holes though the
front bar stock (3/4x1.5) at the same angle as the holes in the legs. Use
fender washers to acommodate the large the holes in the original mounts.
The rear mounting holes will line up with the original holes in the floor.
Gerard
At 8:16 AM -0700 7/30/01, Bob Drake wrote:
>Hi Folks
>I'm currently putting a '74 Midget back together.
>I've got this lovely new rug set but the car had virtually no intact rugs
>for me to use as a guide. Mostly I've figured it out but ... Where do the
>sound-deadening pads go?
>Second question. The seats were beat. I got a pair of Miata seats from the
>local wrecker. Now for those who have done this...did you remove the two
>pointy pieces at the front of the rails? If so, did you then straighten the
>front ends of the rails so they lie flat?
>Thanks
>Bob
--
Please visit Four Points Travel -
Discount Online International Travel Reservations
http://www.gerardsgarage.com/fourpoints
To make a reservation please call Toll Free 1-800-272-3253
G G Gerard Chateauvieux
E A
R R pixelsmith@gerardsgarage.com
A A
R G Pixelsmith on Duty
D E
S http://www.gerardsgarage.com
|