spridgets
[Top] [All Lists]

Re: engine removal prep.

To: "Robert Van Kirk" <racerbob@hotmail.com>, <tob.sprite.landcruiser@home.com>, <spridgets@autox.team.net>
Subject: Re: engine removal prep.
Date: Thu, 7 Sep 2000 15:37:17 -0700
References: <LAW2-F103x8dyDd3OJX00004924@hotmail.com>
Correct you are!  I was thinking about them, but I can't type as fast as I
think, so I forgot.  Does that make sense?
David Riker
74 Midget
63 Falcon
70 Torino
http://personalweb.sunset.net/~davidr
----- Original Message -----
From "Robert Van Kirk" <racerbob at hotmail.com>
To: <davidr@sunset.net>; <tob.sprite.landcruiser@home.com>;
<spridgets@autox.team.net>
Sent: Thursday, September 07, 2000 9:53 AM
Subject: Re: engine removal prep.


>     David and Toby, I beleive you forgot the four bolts down deep in the
> valence uusally under the horns.  You know the ones that the tops are
> usually rusted so bad you can't get a socket on them. BOB
>
>
> >From: "David Riker" <davidr@sunset.net>
> >Reply-To: "David Riker" <davidr@sunset.net>
> >To: "Toby Atwater" <tob.sprite.landcruiser@home.com>,   "Spridgets list"
> ><spridgets@autox.team.net>
> >Subject: Re: engine removal prep.
> >Date: Wed, 6 Sep 2000 21:13:58 -0700
> >
> >Toby:
> >The assembly you are trying to remove is welded together as one piece and
> >includes the valence between the fenders below the grill. It has three
> >bolts
> >per side to the bottom of the fenders, three bolts per side to the
radiator
> >supports, and two bolts per side to the tops of the fenders, and it is
the
> >only thing holding the front of the fenders to the car. In most cases the
> >engine/transmission is removed by lifting them over the front assembly.
> >David Riker
> >74 Midget
> >63 Falcon
> >70 Torino
> >http://personalweb.sunset.net/~davidr
> >----- Original Message -----
> >From: "Toby Atwater" <tob.sprite.landcruiser@home.com>
> >To: "Spridgets list" <spridgets@autox.team.net>
> >Sent: Wednesday, September 06, 2000 8:11 PM
> >Subject: engine removal prep.
> >
> >
> > > Quick question,
> > >
> > > In order to remove the cross peice where the hood latches shut, to
> > > facilitate engine removal, must both fenders be removed? I got all the
> >bolts
> > > I could see out (8 or so) but it still just wiggles a bit. The
radiator,
> > > shroud, and oil cooler are already out of the way.
> > >
> > > Any help is appreciated
> > >
> > > Toby
> > >
> > > 69 Sprite
> > > 69 Midget
> > >
> >
> >
>
> _________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>
> Share information about yourself, create your own public profile at
> http://profiles.msn.com.
>



<Prev in Thread] Current Thread [Next in Thread>