swiss army knife?
chuck.
----- Original Message -----
From <RBHouston at aol.com>
To: <ulix@u.washington.edu>; <spridgets@autox.team.net>
Sent: Sunday, June 25, 2000 5:36 PM
Subject: Re: Bad generator bearing
> In a message dated 06/25/2000 12:27:11 AM Mountain Daylight Time,
> ulix@u.washington.edu writes:
>
> > Is it feasible to change the bearing? Do I need special tools? Should
> > I let a professional handle it?
> >
> > Thanks,
> > Ulix
>
>
> Ulix, it been over thirty years since I've done one but I seem to remember
> removal was punch it out with a small drift, or prise it out with the
middle
> sized Craftsman screwdriver.
>
> Of course, chuck can probaly tell you haw to do this in the dark, in the
> rain, in a foxhole, with nail scissors....;-)
>
> Bearing should be standard size.
>
> RH
>
|