I am not sure the screw is big enough for this. I have seen a racing E-Type
on triple DCOE with the jet inspection cover wired to the fuel filter fitting
as you suggest - however, if you take a look you will see that this is not as
simple as it seems and not a job I am going to attempt myself (even if I did
have a pillar drill).
Thanks for your ideas.
Daniel1312
In a message dated 02/05/00 16:08:43 GMT Daylight Time, branch@valinet.com
writes:
<< About the jet cap wiring....how about drilling one ear of the micky mouse
cap
and wiring it to a hole you would have to drill in one of the float bowl
cover
screws. Should be able to do this with a hand held drill, I think. Or wire
around the fuel filter fitting (not so pretty, and not really official).
Or,
on my carb there is an unused hole on the LH side next to the butterfly shaft
bushing (probably for the idle rpm set screw in some installations?)
>>
|