spridgets
[Top] [All Lists]

Re: U Joint Zerk 70 Midget

To: "spridgets" <spridgets@autox.team.net>
Subject: Re: U Joint Zerk 70 Midget
Date: Thu, 13 Apr 2000 12:35:11 -0400charset="iso-8859-1"
References: <005401bfa53b$8ca46220$4a3dd0ce@user>
I don't know yet, but I hope not.  I have one of those, too.

Steve Byers
Havelock, NC USA
'73 Midget GAN5UD126009G  "OO NINE"


----- Original Message ----- 
From Larry Cogan <woodrat at spacey.net>
To: Steve Byers <byers@cconnect.net>
Cc: Spridget List <spridgets@autox.team.net>
Sent: Thursday, April 13, 2000 7:29 AM
Subject: Re: U Joint Zerk 70 Midget


> Jeeze o pete....is the Miata the same way as its stable mates?  Does it have
> to come off my dream list too? Say it isnt so.  Larry
> 
> 
> -----Original Message-----
> From: Steve Byers <byers@cconnect.net>
> To: spridgets <spridgets@autox.team.net>
> Date: Wednesday, April 12, 2000 10:37 PM
> Subject: Fw: U Joint Zerk 70 Midget
> 
> 
> >A co-worker has a Mazda  RX-7 that was making a noise he couldn't identify.
> I
> >listened to it and diagnosed a worn rear u-joint.  Off he goes to the parts
> >store and buys a replacement, and he and I set about replacing it.  When I
> got
> >under the car and looked, I saw that the bearing cups were retained by
> crimping,
> >rather than the usual circlips --- but hey, he had the replacement joint.
> We
> >forced the cups out, then discovered that the replacement cups were way too
> >small to fit.  A recheck with the parts store and the Mazda dealer
> determined
> >that you can't replace the u-joints --- you have to buy a new drive shaft,
> at
> >$400 plus!   Jeez!  Talk about disrespect for the consumer!
> >
> >Steve Byers
> >Havelock, NC USA
> >'73 Midget GAN5UD126009G  "OO NINE"
> >"It is better to remain silent, and be thought a fool
> >than to speak, and remove all doubt"  -- Mark Twain
> >
> >----- Original Message -----
> >From: HFC <froggi@cdsnet.net>
> >To: James Algar <JamesA@HI-TORQUE.com>
> >Cc: Spridget List <spridgets@autox.team.net>; 'Larry Cogan'
> <woodrat@spacey.net>
> >Sent: Wednesday, April 12, 2000 9:40 PM
> >Subject: Re: U Joint Zerk 70 Midget
> >
> >
> >> ...get this.  You can't even replace U's on a Mazda 929.  A tranny shop
> takes
> >> your drive shaft, cuts and modifies to accept  replaceable U-Joints!
> Where's
> >> the logic here. I'm sure there are others like this.
> >>
> >> WFO
> >>
> >
> >
> >
> 


<Prev in Thread] Current Thread [Next in Thread>