Re: U Joint Zerk 70 Midget

In a message dated 04/13/2000 5:23:13 AM Central Daylight Time, 
DLancer7676@cs.com writes:

<< 
 On the non-zerk u-joints, is there any way to drill and tap a zerk into them 
 so one might make them greasable?
  >>

I would suspect you "could", David, but the orientation is CRITICAL and you 
would still need the long zerks.  

Seems to me the easier route is just order the right ones already "zerk 
ready". 

That's what I stock.

Cheers.........

       Ed