Is the threaded portion of the spoke protruding out the back side of the
nipple ? If so you could grind them flush with a dremmel tool.
Are there loose spokes ? Is it only happening to one wheel. If everything is
OK one rubber band should be enough.
If all else fails call British Wire Wheel and see what they think.
Good luck ,
Mark Hanna
AN5
> -----Original Message-----
> From: William M. Gilroy [SMTP:wmgilroy@lucent.com]
> Sent: Wednesday, February 23, 2000 1:04 PM
> To: Larry Macy; spridgets
> Subject: Re: Wire Wheel???
>
> Larry Macy wrote:
> >
> > Can I get a wider band? Cut up some tubes? Seal them and go tubeless??
>
> How about gluing two bands together with about an inch of overlap.
> You could try using PVC cement, modeling glue, or a silicone caulk.
> Something like a PVC cement that would melt the band a bit might
> work well. You would then have one wide band. Just an idea and
> I never tried this, not even on TV.
>
> Bill Gilroy
|