spridgets
[Top] [All Lists]

Re: Size of Crankshaft pulley bolt?

To: curt.onstott@orst.edu
Subject: Re: Size of Crankshaft pulley bolt?
Date: Tue, 25 Jan 2000 18:06:57 -0800
Cc: spridgets@autox.team.net
Organization: WFO Racing
References: <47D8A62215E3D211A0890000C01530FD0170D660@pan.nws.orst.edu>
...what's a "RockHopper"?

I think the nut is 1 5/16.

WFO Herb in Grants Pass...as in Oregon
Keep the sticky side down!

curt.onstott@orst.edu wrote:

> I pulled my engine on Saturday.  It was still running on three cylinders and
> I took the car on one last drive beforehand.  I expect it to be laid up
> until Summer.  Needs a full engine rebuild and a Datsun tranny transplant.
> What size of socket do I need to get the Crankshaft pulley bolt off of my
> 1275?  I'd rather use my impact wrench than a hammer and chisel :)
>
> Curt Onstott - Crop and Soil Science Computing Admin
>   Oregon State University. - (541) 737-5875 - Office: CrpS 153b
>                     http://www.css.orst.edu/curt
> No, life IS a contest.  Perhaps it doesn't FEEL like a contest to YOU
>                 because I WON so long ago.  -Voorhis
>   '70 MG Midget    '75 Jaguar XJ6     '95 Specialized RockHopper


<Prev in Thread] Current Thread [Next in Thread>