Man Daniel,
Got your message just a little too late!<grin> Spent some time last night
grinding the intake manifold on the DGV carb and it seems to have fit a
lot better. Haven't tested it yet though. I put some gasket gunk on it
to make sure it was sealed, in case a 1/16th of an inch gap was left. It
should be cured by the time I get home, and I can't wait to give it a run!
Greg Gowins
'69 Sprite
Dublin, CA
On Thu, 16 Sep 1999 Daniel1312@aol.com wrote:
> Greg,
>
> I think you should stop mucking about with SUs and get a 45 DCOE!!!
>
> Daniel1312
>
> In a message dated 16/09/99 02:29:34 GMT Daylight Time, cartman@dnai.com
> writes:
>
> << Frank,
>
> Thanks, but you missed your cue. I was WANTING you to tell me it was a no
> go, and I had to get DCOEs...<grin> Thanks for the tip. I'm pulling out
> the Makita as we speak to try and grind the manifold down to fit. Thanks
> again for the tip!
> >>
>
|