Just Did this on My "62 w/ 1275. Tight fit, but it will go. Jack that side
up off the ground so as not to hit the pipe into the ground. It should pass
through the little triangle area between the frame and the fender. You'll
probaly have to bend the lip of that out some. I remember that it was tight,
I forced it a little and it poped right in. I know this isn't much help. But
it can be done. Get it done so you can go on the 49 trip.
-----Original Message-----
From: Greg Gowins [mailto:cartman@dnai.com]
Sent: Saturday, September 04, 1999 2:51 PM
To: Spridgets List
Subject: Installation help with Maniflow header
Hello fellow listers,
I need to ask for a bit of assistance on the installation of the Maniflow
LCB Exhaust header. How the @#*#%* do you install the thing? I can fit in
backwards, but that doesn't do any good. When I try and place it in the
correct way, it seems to keep hitting the area around the brake cylinder,
and can't get the bottom of the header through the space behind the wheel.
Any tips are appreciated!
Greg Gowins
'69 Sprite
Dublin, CA
|