I'm sure that I have seen a square bdy sprite with the anti-roll bar mounted
"up-side-down" - that is with the short link arms pointing upwards from
their mounting brackets on the lower wishbone plate.
This would increase ground clearance
Not tried it, but it would be an easy thing to do.
Anyone done that ?
Guy
----- Original Message -----
From: Ulix Goettsch <ulix@u.washington.edu>
To: Phil Vanner <pvanner@pclink.com>
Cc: Spridget List (E-mail) <Spridgets@autox.team.net>
Sent: 14 June 1999 16:03
Subject: Re: Sway Bar mountings
>
> I think recessing might be a good idea to gain that extra little bit of
> ground clearance.
>
> Ulix __/__,__ ___/__|__
> ..............................................(_o____o_)....<_O_____O_/...
> http://students.washington.edu/~ulix/ '67 Sprite '74 X1/9
>
>
>
|