>Andy,
>
>How's the run-on problem coming?
>WFO Herb
>
Not too good thanks Herb. I tried enriching the mixture a bit by turning
that nut on the bottom of the carbies, but I'm not real sure of what I'm
doing and now its running like a dog. I think I'll take it for a tune up at
a LBC specialist and ask if I can observe and learn the tricks of S.U
tweaking...Any hints for me? I would prefer to do it myself and keep the
cash
Andy
>
> > Herb
> > I would have if I hadn't done a valve grind just before getting the car
>back
> > on the road.The bores and piston tops were squeaky clean too.
> > How fast does buildup build up?
> > Andy
> >
> > >From: HFC <froggi@cdsnet.net>
> > >Reply-To: froggi@cdsnet.net
> > >To: andy webster <trunkie@hotmail.com>
> > >CC: Daniel1312@aol.com, spridgets@autox.team.net
> > >Subject: Re: Octane & CRs was Re: Automotive calculations for dummies
> > >Date: Sat, 08 May 1999 15:17:10 -0700
> > >
> > >Andy,
> > >
> > >Did you consider carbon build up?
> > >WFO Herb
> > >
> > >andy webster wrote:
> > >
> > > > No fair!
> > > > I'm getting dieseling after switch-off and I suspect a bit of
>knocking
> > >with
> > > > 96 octane leaded. I've only got ~9:1 CR, whats goin on?
> > > > Is my ignition timing up the khyber?
> > > > Andy
> > > >
> > > > >From: Daniel1312@aol.com
> > > > >To: kturk@ala.net, trunkie@hotmail.com, spridgets@autox.team.net
> > > > >Subject: Octane & CRs was Re: Automotive calculations for dummies
> > > > >Date: Sat, 8 May 1999 15:37:54 EDT
> > > > >
> > > > >In a message dated 07/5/1999 7:47:31PM, kturk@ala.net writes:
> > > > >
> > > > ><< Yeah there is nothing about this that should work... especially
>with
> > >no
> > > > > lead.....
> > > > > >>
> > > > >I am not sure what petrol is used. It might be 98 (English method
>of
> > > > >calculation) octane unleaded or 95 leaded. I don't think they use
> > > > >additives
> > > > >but the guys that run 15:1 CRs might.
> > > > >
> > > > >For myself I ran 11:1 on standard 95 leaded with no problems (on a
>full
> > > > >race
> > > > >mixture strength).
> > > > >
> > > > >
> > > > >Daniel1312
> > >
>
|