Jackson,
what a superb treatment of the issue!
Could you tell us what offset your rims have (or what rims you are using)
and what spacers you had to use? Do you have a good source for wheel
spacers?
I have a set of wheels with the RE71Rs for my Fiat and was very pleased to
hear your comments since I haven't mounted them yet. I was a little
scared of the wet performance since I drive in the rain almost every day
(Seattle).
> 7) Install the tires, take a good look, and make sure that nothing is
> touching. Take the car for a ride down a nearby BUMPY, TWISTY road and
> listen. If you need to do more work, you WILL hear it. If you hears
> rubbing/grinding, slow down, do whatever it takes to minimize the
> rubbing as you are driving, and get home. When you get back home, pull
> off the rear wheels and look for polished areas in the rear or areas
> with black ground tire residue and work on those sections. Repeat until
> no rubbing.
I also used a bottle jack and then ground away a little at the fender lip,
not enough to get to the spot welds. I used some paint to cover the
potential rubbing areas and the lip and went for a spin. Afterwards I'd
see where the paint had rubbed off and work on that area, then repaint and
drive again. This way it is easy to find out where it rubs.
Ulix __/__,__ ___/__|\__
..............................................(_o____o_)....<_O_____O_/...
'67 Sprite '74 X1/9
|