> The clutch release bearing has gone south on the 74. A short squeal and
> then the clutch no longer engages.....or only engages about half way.
>
> Question - Did I read something about an upgrade for this release
> bearing, and if so, what are the particulars and where do I get the
> part???
Kevin,
I just put my '74 Midget back on the road after major steel, paint,
and engine work. I installed a roller bearing release bearing from
MiniMania and it works very well. I also put in a teflon braided
hose from Moss, and the combination feels very good. The worst part
is getting the hydraulics bled again, but I found a technique that
seems to work.
Regards,
Rick Brodeur
'74 MG Midget daily driver (again)
'61 Big Healey tri-carb (next project)
|