While that might work, it is much easier to work with the double stick
tape. You can apply the tape to the back of the badge and leave the
backing on the outside of the sticky surface. Using a very sharp knife
(Xacto works great) it is easy to trim the tape precisely along the
badge. You can ever use it to install broken badges by spanning the
break. The joint is scarcely visible!
Cheers,
Joe
Andre Rousseau wrote:
>
> Clear silicon?
>
> On 11/14/02 3:05 PM, "Joe Curry" <Spitlist@gte.net> wrote:
>
> > Jeff,
> > Cut the posts off the badge and use double stick auto trim adhesive to
> > put it on. Then there is no need to worry about the holes lining up.
> > Just make sure you cover them up! :)
>
> --
> Andre Rousseau - Ottawa Canada
> 1968 Triumph GT6 MK1
> http://www.justdrive.ca/
> andrer@mac.com
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|