Hi, Alan.
The 9.5 ohm value is useful, but are there two at 9.5 each? One 9.5
with a center (or other fraction) tap? Three terminals means two
resistors, in one form or another (or some solid-state active device.)
Still curious
Donald.
> From: ralemen@cableone.net
> Date: Thu, 12 Sep 2002 12:29:12 -0700
>
>
> The drive resistor value (it's actually marked on it) is 9.5 ohm. That's all
>I can contribute as that the only part I have.
> I did see a schematic once (me thinks it must have been on the web) of one of
>those and all it had was a couple of power transistors etc. So acting as a
>pull-up would make sense. I'll scratch around and see if I turn it up again.
>
> Alan
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|