spitfires
[Top] [All Lists]

O/D

To: "List Spitfires" <spitfires@autox.team.net>,
Subject: O/D
From: "Graham Stretch" <technical-iwnet@lineone.net>
Date: Sat, 12 Feb 2000 23:45:15 -0000
Hi All
A while ago I replied to a mail saying about slow A type O/D engagement,
stating that mine took forever to engage, I timed it Friday at 3 miles
(genuine ones) at 60MPH from flicking the switch to full engagement and
about 2 miles before anything happened at all. I then came home and followed
the workshop manual fix which reads:  "Access to the operating valve plug is
gained by the removal of the console tray and the rubber grommet forward of
the gear lever. Operate the solenoid several times to release hydraulic
pressure. Unscrew the valve plug and with the aid of a small magnet, remove
the spring plunger and ball. Taking care to avoid damaging the valve
seating, remove the valve by inserting a piece of stiff wire down its centre
and drawing it up. Ensure that the small hole which breaks through from the
centre drilling at the bottom of the valve is not blocked. this hole
exhausts oil from the operating cylinders when the valve is moved to its
direct drive position.
If necessary the ball can be re-seated as follows: Place the ball on a block
of wood, position the seat of the operating valve on the ball and give the
valve a sharp gentle tap. Clean the valve seat in the casing, place the ball
on its seat and gently tap the ball with a copper drift. avoid tapping the
ball too hard otherwise the mouth of the hole will be closed slightly and
prevent reassembly of the valve.
Seems easy enough right? Wrong the plug is about six inches away from the
hole and on such an angle that the hole could have been 2" to the right to
make it visible. Take out the gearstick grommet plate and you have somewhere
to look and shine the torch while you work through the other hole. Take the
bits out with a magnet works, how do you get them back? Precision bombing!
You hold them in long nose pliers and let go when your sixth sense tells
you. Re-seating the valve rod, use several very light blows from the hammer
to re-form the shape then spin it with your fingers to generate a slight
polishing of the seat, leaves a slight "witness ring" on the seat. to re
seat the ball down the hole you will need something like 3/8" rod with about
a 15 degree bend in to get it in the hole in the box and out the hole in the
tunnel so you can hit it. The result as ever is a job with about an hour
time budget takes three hours, the effect is that an O/D that took three
miles now only takes about 30 feet or a couple of seconds, verdict, well
worth the effort. The above was for a 2000 2500 saloon but I dare say the
job is just as awkward on a TR or any other car fitted with an A type O/D.

Hope this helps someone some when!!
Graham.


<Prev in Thread] Current Thread [Next in Thread>
  • O/D, Graham Stretch <=