I have dropped the pan, but will fluid drain out all over?
-- Bob
> -----Original Message-----
> From: shotimes-admin@autox.team.net
> [mailto:shotimes-admin@autox.team.net] On Behalf Of Robert Bruce
> Sent: Wednesday, July 19, 2006 4:28 PM
> To: Shotimes@autox.team.net
> Subject: RE: [Shotimes] Torque Converter to Flexplate Nuts
>
> You need to separate the transmission from the engine first.
> Take the tranny out of the car, leaving the torque converter bolted to
> the flexplate. Then you will be able to easily use a socket
> and ratchet to remove the bolts.
>
> Bob
>
> -----Original Message-----
> From: shotimes-admin@autox.team.net
> [mailto:shotimes-admin@autox.team.net] On Behalf Of Bob
> Sent: Wednesday, July 19, 2006 12:33 PM
> To: Shotimes@autox.team.net
> Subject: [Shotimes] Torque Converter to Flexplate Nuts
>
> How do I get them off?
>
> I'm unable to get a socket on them, and I can tell an open
> ended wrench would tear them up. I started modifying a box
> wrench, but
> there's not enough curve at the box end to clear the bellhousing.
>
> -- Bob
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes
|