Gil
I'm just going through the same mental exercise - I'd appreciate your
sending on any good info you get that's not also copied on the list.
To the List - Are Walnut Shells better than plastic media for aluminum
[and other] parts that end up inside the engine?
Derek
Gil Fuqua wrote:
>
> I am looking for a table-top abrasive blaster cabinet, primarily to clean
> aluminum parts, such as a distributor housing. I already have a large Tip
> blaster cabinet that I use with glass beads. It is too aggressive on the
> aluminum and was thinking about using plastic media.
>
> Any thoughts on media and a supplier for a small abrasive cabinet. Harbor
> Freight has several and would welcome comments or suggestions on the models.
>
> ---
> Gil Fuqua, Jr.
> Corporate Communications, Inc.
> 523 Third Ave S.
> Nashville, TN 37210
> 615-254-3376 ex 311
> fax 615-254-3420
|