Using the aforementioned Craftsman Professional 6-hp oilless compressor, cfm
rating 11 @90 psi, with a D/A sander, the compressor would stop altogether
for about 15 minutes. Then it would presumably cool down and start again.
It was only running the one sander, albeit more or less continuously. Is
this just exceeding the duty cycle? This is normal? Any way to reduce or
eliminate this, short of buying another compressor?
Rex Burkheimer
J-CON Coordinator, WM Automotive Whse Fort Worth TX
Texas Region SCCA FC #19 ITB #49
rex@inoli.com rburkheimer@hotmail.com
The Meek shall inherit the earth..
...after we're through with it.
DFW Internet Service $9.95 /month, 1st month free, no setup charge
All 56K digital, no busy signals over 200 N Texas cities
www.inoli.com or toll free 1-877-308-4665
|