Dunst, Mordecai writes:
>
>
> 1/2" (long) stud broken in block--3/8" proud of the deck. Any
> suggestions.
>
> I've tried penetrating oil-soak, heat, banging to and fro, trying to
> tighten it just a soach,...what I'm left with is EDM ($$$).
Use a Dremel tool with a cut-off wheel to cut a slot in the top and
then use an impact wrench (not an air wrench, this is
the kind you hammer on) with a straight bit in it to loosen it.
Centerpunching and drilling it first would be a good idea, sometimes
drilling a hole lengthwise makes it come out easier.
--
Eric Murray ericm@lne.com Network security and encryption consulting.
PGP keyid:E03F65E5 fingerprint:50 B0 A2 4C 7D 86 FC 03 92 E8 AC E6 7E 27 29 AF
|