I know this topic has come up several times, but I think I've narrowed
my decision down to two choices, and I'd appreciate any input from the
list. I'm 90% sure that I'm going to tackle the paint job on my 1950.
For a lot less than the cost of a good paint job, I could buy all the
equipment, save a ton of money, have a little "fun," and maybe learn
something along the way. It's been recommended to me that I should be
looking for a compressor capable of 13 CFM at 90 PSI to paint a vehicle.
Keeping in mind that a big air compressor would be cool, but that after
this job, I may never need a compressor quite this capable again. Then
again, I might. As is the case for most of us, money is an object, so
I'm considering the following:
(1) Kobalt model K7060HFV from Lowe's. 7HP, 60 gallon, 13.3 CFM @ 90
PSI, $499.00.
(2) U.S. General model 93274-0VGA from Harbor Freight. 5HP, 60 gallon,
15.8 CFM @ 90 PSI, $799.00.
I'm leaning heavily toward the Kobalt model. Does anyone have any
comments regarding either choice? I know Harbor Freight is not
necessarily known for quality. Is there any chance that their
compressor rated at 15.8 CFM is worth an additional $300?
Thanks for any input.
Mark Mintmier
1950 Chevy 3100
|