Check with Kanter Automotive, sorry I don't have an address because all of
my stuff is packed for moving. Kanter carries a lot of parts and rebuild
stuff for the Pontiac/GMC motors. You might also check with the Pontiac
specialty places, they should use the same rocker arm studs. You might
also check the Hot Rod shops, I think the 389ci Pontiac may (not sure) use
the same studs. Good luck.
Kevin Lake
56 GMC Suburban/napco
----------
> From: jvanho01@tir.com
> To: oletrucks <oletrucks@autox.team.net>
> Subject: [oletrucks] Rocker Arm Studs
> Date: Wednesday, May 26, 1999 6:22 PM
>
> I have checked just about everywhere I know to check and have not been
> successful in locating replacement rocker arm studs for my 58 V8 GMC
> engine. These would be screw in type rather than pressed in. Also, they
> are hollow from the bottom side with a side hole to oil the rocker arm.
> Any thoughts or help would be greatly appreciated.
>
> Thanks,
>
>
> Jim V. - '58 GMC Suburban Carrier Pickup V8 Automatic
> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|