Thanks Paul! That was what I expected just want to be sure before buying
one. From my set I have tried 1 1/16" and 1 1/4" and of course they
were not matching but I couldn't see if it is because of the wrong size
or for some other reasons.
peter
-----Original Message-----
From: Paul Hunt [mailto:paul.hunt1@blueyonder.co.uk]
Sent: Friday 20 January 2006 10:53
To: mgs@autox.team.net; Peter Bona
Subject: Re: Forwarded: hub nut
1 1/8" AF.
FWIW the rear hub nut on the Salisbury/tube type axle is 1 5/16" AF,
same as for the crankshaft pulley nut. If you use a 1/2" socket drive
then a standard socket should fit inside the wire wheel hub. If you use
3/4" drive or impact sockets you may need to get a harder to obtain
thin-wall socket.
PaulH.
----- Original Message -----
> My first question would be if anyone knows what size of socket is
> needed to remove the front hub nut
This communication may contain confidential and/or proprietary information and
is intended only for use of the recipient(s) named above. It is not intended to
create or affect any contractual arrangements between the parties. If you have
received this email by mistake, please notify the sender and delete it
immediately. BASE is not liable for the integrity and security of this message.
|