Re: Forwarded: hub nut

["Paul Hunt" <paul.hunt1@blueyonder.co.uk>]

1 1/8" AF.

FWIW the rear hub nut on the Salisbury/tube type axle is 1 5/16" AF, same as
for the crankshaft pulley nut.  If you use a 1/2" socket drive then a
standard socket should fit inside the wire wheel hub.  If you use 3/4" drive
or impact sockets you may need to get a harder to obtain thin-wall socket.

PaulH.

----- Original Message ----- 

> My first question would be if anyone knows what size of socket is needed
> to remove the front hub nut