Re: Never under estimate your DPO. (If you had one...)

mgs

Re: Never under estimate your DPO. (If you had one...)

To:	MG Nuts <mgs@autox.team.net>
Subject:	Re: Never under estimate your DPO. (If you had one...)
From:	Skye Poier <skye@ffwd.cx>
Date:	Mon, 16 Sep 2002 16:39:02 -0700

Must be a new DPO method for setting the end float :P

Skye

Word on the street is Telewest PH" said:
> Not quite sure what the meaning of your 'not too surprising' is but the
> front hub nuts are supposed to be torqued to between 40 and 70 ft lbs.  The
> wide 'tolerance' is to allow one of the split pin holes to be lined up.  The
> rears are 150 ft lbs and to the next hole.

--
1966 MGB - GHN3L     Safety Fast!             __,__\__ 
The MGB Experience   www.mgbexperience.com   (_o____o_)

///  or try http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive

[More with this subject...]

<Prev in Thread]	Current Thread	[Next in Thread>
Never under estimate your DPO. (If you had one...), Andrew B. Lundgren Re: Never under estimate your DPO. (If you had one...), Telewest \(PH\) Re: Never under estimate your DPO. (If you had one...), Rick Lindsay Re: Never under estimate your DPO. (If you had one...), Andrew B. Lundgren Re: Never under estimate your DPO. (If you had one...), Bill Meyer Re: Never under estimate your DPO. (If you had one...), Andrew B. Lundgren Re: Never under estimate your DPO. (If you had one...), Bill Dudley Re: Never under estimate your DPO. (If you had one...), Charles & Peggy Robinson Re: Never under estimate your DPO. (If you had one...), Skye Poier <=

Previous by Date:	Slow speed rattle, Mike Winney
Next by Date:	Re: Inner sill rust protection on BMH Body Shell, Skye Poier
Previous by Thread:	Re: Never under estimate your DPO. (If you had one...), Charles & Peggy Robinson
Next by Thread:	Inner sill rust protection on BMH Body Shell, Don Malling
Indexes:	[Date] [Thread] [Top] [All Lists]