Not too surprising for my DPO. When I find things that are just
stupid, I am no longer too surprised by them.
I no longer remember all the stupid things I have corrected on my car.
Looking at the hubs, the left and right sides don't seem to be matched
either... Unless one side wore a lot faster than the other.... (Both
front and back, not just the back, IIRC, one rear outwears the other.)
On Thu, 12 Sep 2002 09:32:54 +0100, Telewest (PH) wrote:
>Not quite sure what the meaning of your 'not too surprising' is but the
>front hub nuts are supposed to be torqued to between 40 and 70 ft lbs. The
>wide 'tolerance' is to allow one of the split pin holes to be lined up. The
>rears are 150 ft lbs and to the next hole.
--
Andrew Lundgren
lundgren@byu.net
http://www.Lundgren.us
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|