mgs
[Top] [All Lists]

Re: Delurk and Rot Repair Question

To: "Scotsman" <scotsman@worldnet.att.net>, "MGS Digest" <mgs@autox.team.net>
Subject: Re: Delurk and Rot Repair Question
From: "Paul Hunt" <paul.hunt1@virgin.net>
Date: Mon, 15 Nov 1999 10:30:34 -0000
I'd say 'Yes' to the below, plus leave the doors on to get good alignment of
the sills to them, at least until you have tack-welded them.

On the question of bracing, it can't hurt - as long as you have the car
supported in the manner you intend to work on it before you weld them in -
although I have not seen this recommended for a B, but always for a Midget.

PaulH.

-----Original Message-----
From: Scotsman <scotsman@worldnet.att.net>
To: mgs@autox.team.net <mgs@autox.team.net>
Date: 14 November 1999 20:30
Subject: Re: Delurk and Rot Repair Question


>The wealth of knowledge here truly is priceless!
>
>I am beginning to make the conclusion that I should:
>
>1.  Replace sills
>2.  Replace crossmember
>3.  Replace floors
>
>In that order.  Am I on the right track?
>
>From those that have done this work, what is your opinion on the source of
>the replacement parts?
>
>I have catalogs from Moss, BV and TRF.  I am also aware of Obsolete in
>Canada.  Is there any difference in the panels from these sources?  Am I
>overlooking any other potential source.
>
>Thank you all for your advice!
>
>



<Prev in Thread] Current Thread [Next in Thread>