At 10:33 AM 8/21/99 -0600, Phil Bates wrote:
>I'm not sure which model MG you have, but I suspect an MGB. .... It is
usually about a 4 hour job in total. If you have an MGA it may be a little
more difficult, because you have to lift or drop the back of the car to get
the right geometry to get the engine out of the bay. I am down to about 2
1/2 hours on the MGA - I had to pull it 4 times last year.
I pull the MGA engine first, 1 hr 20 min, then the gearbox, another 20 min.
Only once did I try pulling the engine and gearbox together. Never again!
And I've already pulled the engine twice this year.
Barney Gaylord
1958 MGA with an attitude
http://www.ntsource.com/~barneymg
|