mgb-v8
[Top] [All Lists]

OIL LEAK

To: Buick-Rover-V8 Mail List <buick-rover-v8@autox.team.net>
Subject: OIL LEAK
From: Gregory Williams <gwilliams@servicesoft.com>
Date: Wed, 16 Aug 2000 13:06:24 -0400
Cc: mgb-v8@autox.team.net
Reply-to: Gregory Williams <gwilliams@servicesoft.com>
Sender: owner-mgb-v8@autox.team.net

 Subject:
      OIL LEAK - REAR CRANK SEAL, drip drip
 Date:
      08/14/2000
 Author:
      Bryan Daley <bryan.daley@nz.logical.com>


           
                                                     

 Help,
  
 Before removing the engine for the 3rd time thought I'd actually seek some
wison!
 My engine has an oil leak at rear crank seal.
 I have replaced the seal once with no effect. Then  I moved the new oil
seal so that it is flush with the outside of the block,
 which reduced the leak slighlty.
  
 Any suggestion/s would be very welcomed (fixing the oil leak suggestions
that is)
  
 One suggestion so far has been to shorten the wire spring inside the seal
to increase the tension that the seal places on
 the shalf - has anyone actually done this before?
  
 Footnote - The block is 3.5 RR and the crank is 4.4 Leyland P76.  The P76
oil seal is almost identical to the standard 3.5
 except it has a larger diameter.  The block and rear mains were line bored
to accept the larger diameter seal.  I have
 checked to make sure that the enlarged seal recess has the same centre as
the crank - and it does.
  
 Thanks
  
 --
 Bryan Daley, SII, RR
 http://homepages.paradise.net.nz/bdaley/index.html
 Wellington, New Zealand, where the grass is greener.

<Prev in Thread] Current Thread [Next in Thread>
  • OIL LEAK, Gregory Williams <=