mg-mmm
[Top] [All Lists]

Re: PA Cylinder Head

To: <viv@trax.co.za>, <mg-mmm@autox.team.net>
Subject: Re: PA Cylinder Head
From: "Peter Green" <p.green@mgk3.co.uk>
Date: Tue, 16 May 2006 13:28:01 +0100
References: <4469D9CC.8001.124E562@localhost>
Reply-to: "Peter Green" <p.green@mgk3.co.uk>
Sender: owner-mg-mmm@autox.team.net
Viv,

The original depth of a PA cylinder head was 3.641" (3 41/64")

Peter.


----- Original Message ----- From: <viv@trax.co.za>
To: <mg-mmm@autox.team.net>
Sent: Tuesday, May 16, 2006 12:55 PM
Subject: PA Cylinder Head


Can someone tell me the standard measurement of an unskimmed
head?

Is it usual to take a bit off to allow for modern day fuels? If so, how
much is normal and what CR should this give?

Thank you.

Viv

/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/cgi-bin/majorcool
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-mmm
///  Send list postings to mg-mmm@autox.team.net


<Prev in Thread] Current Thread [Next in Thread>