| To: | mg-mmm@autox.team.net |
|---|---|
| Subject: | PA Cylinder Head |
| From: | viv@trax.co.za |
| Date: | Tue, 16 May 2006 13:55:24 +0200 |
| Reply-to: | viv@trax.co.za |
| Sender: | owner-mg-mmm@autox.team.net |
Can someone tell me the standard measurement of an unskimmed head? Is it usual to take a bit off to allow for modern day fuels? If so, how much is normal and what CR should this give? Thank you. Viv /// unsubscribe/change address requests to majordomo@autox.team.net or try /// http://www.team.net/cgi-bin/majorcool /// http://www.team.net/mailman/listinfo /// Archives at http://www.team.net/archive/mg-mmm /// Send list postings to mg-mmm@autox.team.net |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: Smiths/British Jaeger gauges, ian thomson |
|---|---|
| Next by Date: | Re: PA Cylinder Head, Mick Conde |
| Previous by Thread: | Smiths/British Jaeger gauges, Frenken, Eric |
| Next by Thread: | Re: PA Cylinder Head, Mick Conde |
| Indexes: | [Date] [Thread] [Top] [All Lists] |