Don:
I used a short piece of convoluted hose and found it relatively easy to fit.
Later on I replaced it with some of the present day Kevlar plain hose, which
proved every bit as difficult to fit as you and others have described. I
did find that removing the rad connections and the top hose allowed the rad
to be manoeuvred sufficiently to allow wriggle room - but it IS a pig of a
job!
Regards
Dick Morbey
PA 0743
-----Original Message-----
From: owner-mg-mmm@autox.team.net [mailto:owner-mg-mmm@autox.team.net] On
Behalf Of DB35PA@aol.com
Sent: 12 January 2005 20:30
To: mg-mmm@autox.team.net
Subject: bottom rad hose on P type
Anyone have a "trick" for installing bottom rad hose on my P?
I've tried swearing, grunting and wrestling....
Do I need to remove water pump, rad (God I hope not), or both?
Don B.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|