land-speed
[Top] [All Lists]

Re: wandering track

To: land-speed@autox.team.net
Subject: Re: wandering track
From: ARDUNDOUG@aol.com
Date: Sun, 2 Sep 2001 20:59:06 EDT
In a message dated 9/2/2001 3:24:19 PM Pacific Daylight Time, 34ford@msn.com 
writes:


> The ONLY problem I had, since we are criticizing
> the folk that do a fine job at SCTA, is finding the turn off and return 
> road.
> 

       As you get more experience you'll find getting to the return road a 
lot easier. On the short course there are cars and bikes with a wide variety 
of shutoff speeds, anywhere from under 100mph to near 200mph for those 
qualifying for the long course. When I was running on the short course I just 
held the heading I'd been on through the previous 3 miles, initiated and 
completed my engine shut-down procedure, then when the car had slowed to what 
seemed to be a speed at which I could turn out with out spinning I started my 
very gradual right turn. Since there are usually cars scattered along the 
return road there is a reference from which to adjust your radius of turn, 
which dictates where you will intercept the return road. After the first 
couple of passes you'll be able to adjust your track so as to come to a stop 
just short of the return road, facing the starting line, and near a spectator 
who hopefully can give you your time. 
       On the long course the same applies, you just are turning to the left 
and coast much farther before initiating your turn toward the return road.
       My philosophy at the salt has always been to save the chute for an 
emergency. Since my speeds are reasonably low I've found that this practice 
works for me.
       Now, watch the board lite up in response to the previous paragraph.
                                                 Ardun Doug (Save-The-Chute) 
King

///
///  land-speed@autox.team.net mailing list
///  To unsubscribe send a plain text message to majordomo@autox.team.net
///  with nothing in it but
///
///     unsubscribe land-speed
///
///


<Prev in Thread] Current Thread [Next in Thread>