Thanks, David -
I removed the operating rod (metering pin) yesterday and inspected the hole in
the pin. It did not appear to be plugged, and I was able to manually
(mouthfully?)blow through the pin easy enough, while using a paper towel to
catch any crud/evidence. Oil came out, but no crud. I'll clean it and inspect
it more thoroughly this afternoon. I hope the solution will be that easy.
Are there other similar orifices in the oil passages that could cause the same
problems if plugged?
Steve Byers
HBJ8L/36666
BJ8 Registry
Havelock, NC USA
---- David Nock <healeydoc@sbcglobal.net> wrote:
> The operating rod that lifts the actuating check ball has a very
> small bleed hole about 1/3 down the rod if this hole is plugged it
> will be slow at disengaging.
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|