fot
[Top] [All Lists]

[Healeys] Replacing Hypoid Axle Grease Seal

Subject: [Healeys] Replacing Hypoid Axle Grease Seal
From: rchaskell at earthlink.net (Bob Haskell)
Date: Wed, 26 Apr 2017 19:33:16 -0400
References: <43132867524e4ab5b9a8694c6a4acf5c@nafcmb26.exchange.ford.com>
Dan,

I don't think using bolts in the two/three holes will generate enough 
force to push the hub off.  But I haven't tried it.

I use a 3 arm puller; a 2 arm will work.  I made a thick disc (1/2"?) 
that pilots on the end of the axle, has a smaller OD than the ID of the 
bearing, and has a conical shaped hole in the center to accept the drive 
point of the puller.

To remove the bearing from the hub, I use a hydraulic press.  Made a rod 
that presses on the inner race from the seal side.  That goes against 
the ram of the press.  I made some standoffs that the wheel studs fit 
into so the hub is taking the load, not the wheel studs. (Didn't want 
the studs to push out of the hub while pushing on the bearing.)

When installing the bearing back into the hub, you want to apply the 
force on the outer race.  When installing the hub back on the car, apply 
the force on just the inner race.

Cheers,

Bob Haskell
AHCA 3000 MkI registrar
http://www.ciahc.org/registry_3000mk1.php

On 04/26/2017 06:24 PM, Corning, Dan (D.C.) wrote:
> I am trying to remove the rear axle hub and wheel bearing to replace the
> oil seal located behind them.  After removing the axle shaft, retaining
> nut and lock washer, the photo shows the hub and bearing.
>
>
>
> The inner race of the bearing seems to have an interference fit with the
> axle housing.  Can anyone tell me the proper method to remove the hub?
>  Can I use two long ? inch bolts in the threaded holes in the photo to
> ?push? the hub out and then use an appropriate sized bearing driver to
> reinstall?
>
>
>
> Best,
>
>
> Dan Corning
>
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/rchaskell 
> at earthlink.net
>

<Prev in Thread] Current Thread [Next in Thread>