fot
[Top] [All Lists]

[Healeys] Replacing Hypoid Axle Grease Seal

Subject: [Healeys] Replacing Hypoid Axle Grease Seal
From: healeydoc at sbcglobal.net (David Nock BCS)
Date: Wed, 26 Apr 2017 16:09:31 -0700
References: <43132867524e4ab5b9a8694c6a4acf5c@nafcmb26.exchange.ford.com>
Use a three hooked gear puller / slide hammer to remove the hub.


David Nock
British Car Specialists
209-948-8767
www.britishcarspecialists.com

From: Corning, Dan (D.C.) 
Sent: Wednesday, April 26, 2017 3:24 PM
To: healeys at autox.team.net 
Subject: [Healeys] Replacing Hypoid Axle Grease Seal

I am trying to remove the rear axle hub and wheel bearing to replace the oil 
seal located behind them.  After removing the axle shaft, retaining nut and 
lock washer, the photo shows the hub and bearing.

 

The inner race of the bearing seems to have an interference fit with the axle 
housing.  Can anyone tell me the proper method to remove the hub?  Can I use 
two long ? inch bolts in the threaded holes in the photo to ?push? the hub out 
and then use an appropriate sized bearing driver to reinstall?

 

Best, 


Dan Corning



--------------------------------------------------------------------------------
_______________________________________________
Archive: http://www.team.net/archive

Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys


-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/healeys/attachments/20170426/d7f84f01/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>