Weird stuff Jack. I've had the mixture nut run up several flats on it's own
and lean the mix too much to run right, and JK Jackson just found a little
ball in the top of the float lid that was screwing up his car (TR-3 for Tim
Studdard) for quite a while I think so this deal of yours goes into the
slightly weird that drives you crazy list. Good advice for folks.
Never Be beaten by Equipment
Kas Kastner
----- Original Message -----
From: Jack W. Drews
To: fot@autox.team.net
Sent: Tuesday, May 30, 2006 1:28 PM
Subject: [FOT] HS6 carb tips
This message concerns two things - first, the bolt that holds the
float chamber to the carb body, and second, the jet tube.
Bolt - last year that bolt broke in one of my carbs. That's the first
time I had seen that in all these years. I replaced it with a grade 8
bolt, and that one broke in the second event this year. To reduce the
risk of having this problem again, I drilled out the hole in the
float chambers and installed 5/16" bolts in place of the stock 1/4"
bolts. I'm also going to soft-mount the carbs to the manifold. Others
have pointed out the benefits but I never did it on my own car
because I had not had problems attributable to fuel frothing, at
least that I know of. We'll see if this is any improvement.
Jet tubes -- I converted my TR6 to SU carbs last summer. It ran
great, then ran progressively worse, then wouldn't pull itself around
the block. I replaced everything at least twice and just couldn't
find the problem until this spring. I found that the tube that is a
part of the jet tube, that connects it to the float chamber, was
kinked inside the spring covering. It took me a long time to find
that because any time I took out the jet tube it looked okay,even
with the spring covering pulled back. The kink occurred only when the
tube was held in place by the stock choke linkage. That linkage turns
the jet tube just enough to create the force to kink the tube.
When I had my race car carbs apart to increase the size of the bolt,
I checked those tubes too -- and yes, they were also tending to kink.
To alleviate that problem, I removed the choke linkage and
safety-wired the jet tubes in place.
I suppose some manufacturer changed the specs on the little plastic
tube. I have an older set of HS6"s in my junk box and the old ones
had a larger diameter and stiffer plastic tube.
Any comments on all this?
uncle jack
------------------------------------------------
No Virus Found In This Message
Scanned at barracuda.geneseo.net
=== Help keep Team.Net on the air
=== http://www.team.net/donate.html
|